Auto Body Repair & Spray Painting 2, May/June 2014  
Questions: 1 2 3 4   Main
General Comments

Question 1


(a)       (i)         Identify the tool shown in the sketch  above.
                                    (ii)        Name the parts labelled X, Y and Z.
                        (b)       State two uses of the tool identified in 1(a)(i).
                        (c)        State one function of each of the following:

  1. heel dolly;
  2. high-crowned spoon;
  3. body file.


Most to the candidates who attempted this question could not provide the required responses to part (a) and (b) of the question.  The required responses to these parts are given below:

(ai)       mallet
(aii)      X is handle
                        Y is face
                        Z is head.

(b)       -           used in the initial stage for smoothing and roughing out a panel
                        prior to planishing.;
                                    -           used in hot shrinking;.
                                    -           used in aluminium panel repairs.

Powered by Sidmach Technologies(Nigeria) Limited .
Copyright © 2015 The West African Examinations Council. All rights reserved.