|
Question 1
|
- The following materials were supplied:
- mild steel sheet metal 200 mm x 180 mm x 18 SWG for part A;
- mild steel sheet metal 200 mm x 180 mm x 18 SWG for part B;
- mild steel sheet metal 200 mm x 180 mm x 18 SWG for part C;
- one tie-on label.
The diagram below shows an assembly drawing of a chassis frame with cross member. Using the materials supplied, produce the component.
|
| _____________________________________________________________________________________________________ |
| |
( |
|
|
|
