Machine Woodworking Paper 3, May/June 2014  
Questions: 1   Main
General Comments

Question 1


  1. The following materials were supplied:

                        1 piece 45 x 150 x 800 (mm)

  1. Study the drawings carefully
  2. Make the test piece using the timber which has been prepared to the cutting list specification given above.
  3. You may use any of the machines available in your workshop.




                        This was the only, question candidates were required to produce the component
                        shown.  Most candidates could not interpret the drawings properly thus the
                        performance was poor.



Powered by Sidmach Technologies(Nigeria) Limited .
Copyright © 2015 The West African Examinations Council. All rights reserved.